Adding/Deleting a Target for Load Distribution

Add or delete a virtual server to target for load distribution in order to distribute the load of the traffic that has reached the load balancer.

Important: The load distribution algorithm for virtual servers is the "less connections" algorithm.

Adding a Virtual Server to Target for Load Distribution

Add a virtual server to target for load distribution. You can specify multiple virtual servers and register them all at once.

Important: Before you add a virtual server to target for load distribution, the virtual server must be in an operating state.
Warning:

If you change the IP address of a virtual server that has already been registered, load distribution will not be performed for the new IP address. When operations which involve changing of the IP address of a virtual server targeted for load distribution such as the examples below are performed, delete the target virtual server from the load distribution targets, and register it again.

Operation Examples:

  • Rebooting of a virtual server targeted for load distribution while DHCP is enabled
  • Manual changing of the IP address, by a user, of a virtual server targeted for load distribution while DHCP is enabled

Deleting a Virtual Server Targeted for Load Distribution

Delete a virtual server that has been set as a target for load distribution. You can specify multiple virtual servers and delete them all at once.